Products
Contact Us
Request for Quotation
Request for Service Quote
Home » Products » Clinical Accessories » Test Boxes
 
Test Boxes
 
 
Click to enlarge
Dynamic Load Box
 
Part Number: 9438-0103
Quantity: 1 each
  DOM and INT
  The Dynamic Load Box is used to test the stimulus cables and to perform the functional performance tests in the service manual. It is dynamic because when the stimulus cable or Hand-Held Electrode cable is connected to the Dynamic Load Box, the impedance will be 1800 ohms, but when the stimulus is actually delivered to the Dynamic Load Box, it will be 300 ohms (much like a real patient). The Dynamic Load Box also has an internal 300:1 divider that connects to a BNC connector so it can be connected to an oscilloscope to observe the output waveform. It can also be used to validate the calibration of the spECTrum.
Back to Top
 
Click to enlarge
Sensor Strip Box
 
Part Number: 9438-0104
Quantity: 1 each
  DOM and INT
  The Sensor Box is used to test patient monitoring cables with safety leads and to perform the functional performance tests in the service manual. It is configured to test up to four EEG channels and one ECG monitoring channel at the same time. When connected to a signal generator, the Sensor Box can also be used to validate the sensor channel calibration. By setting the signal generator at 1VPP, 5Hz and setting the chart recorder to maximum gain, the signal printed on the chart paper will be full scale when the calibration is correct. This procedure is detailed in the functional performance tests.
Back to Top
     
©2018 MECTA Corporation. All Rights Reserved